BulletPoint A-Pillar Grab Bar Mount with 20mm Ball for Jeep Wrangler JL/JLU & JT

Whether you want to mount a CB radio, handheld radio, action camera, phone holder or switch panel, our aluminum A-Pillar Grab Bar Mount with 20mm Ball is a great solution!

QUICK & EASY INSTALLATION

This ball mount installs on either of the two front A-Pillar grab bars in your Jeep Wrangler or Gladiator. Plus, you can decide to mount it on the top portion or bottom portion of each grab bar. It does not fit rear grab bars.

1. Remove the small top or bottom plastic panel on driver side or passenger side grab handle with a trim removal tool — it will not be reused.
2. Using a 10mm socket, remove the bolt – it will not be reused.
3. Set the Bulletpoint A-Pillar Ball Mount in place and secure it by threading the bolt with the included Allen key.
4. Attach your desired device holder to the 20mm ball mount.

Note: Our pre-built bundles include our micro arm (our smallest arm). We do not recommend mounting anything longer than our 1cm mounting arm.

If you are looking for an even lower-profile installation, check out our Nubby Edition device holders. Please note that there is very minimal clearance between the grab bar and the device holder.

FITMENT

• 2018-2023 Jeep Wrangler JL
• 2021-2023 Jeep Wrangler 4xe
• 2020-2023 Jeep Gladiator

Does NOT fit 2024+ Jeep Wrangler JL or Jeep Gladiator.